Getting started with Fractory.

Getting started with Fractory.

First download the file from the following link:

Unzip the file from and open the Fractory 3.1 folder.
Double click on Fractory.exe to run Fractory.

For more details on using Fractory refer the pdf attached



    • Popular Articles

    • SMPS not turning ON

      SMPS may not turn because of these reasons. 1. SMPS is not getting power supply. 2. SMPS is spoilt 3. SMPS is detecting a short in machine circuit and is auto Shutting. Troubleshooting: Note: Checking SMPS input when machine is on is risky task. You ...
    • Buying a 3D printer.

      3D printing technology is broadly classified into FDM, SLA and SLS printing. We at Fracktal works Manufacture and sell machines related to FDM and SLA. If you need parts printed using SLS you can use our Fractory service. We have mentioned few of the ...
    • Layer Shifting caused by pulley slipping down

      Motor Pulley is mounted on Motor shaft with the help of a grub screw. The pulley acts as a bridge for transferring the motors rotary motion to the belts. The motor pulley comes under high stresses and sometimes may get displaced. The displacement of ...
    • Layer Shifting caused by pulley slipping down

      Motor Pulley is mounted on Motor shaft with the help of a grub screw. The pulley acts as a bridge for transferring the motors rotary motion to the belts. The motor pulley comes under high stresses and sometimes may get displaced. The displacement of ...
    • Error: Heating failed, system stopped! Heater_ID: Bed

      This error is show when the Bed does not reaches the required temperature as set by the machine. To confirm that the error is related to bed you can check the last word of the error which says "Bed".  Schematics of Heater wiring. This error comes ...
    • Recent Articles

    • Removing carriage board - Julia Extended.

      Carriage board is a small board mounted on the carriage. To remove the carriage board follow the steps below. Note: Remove filament before removing carriage cover. 1. Remove carriage cover. The carriage cover is fastened by 2 screws. Please be ...
    • Sending Gcode to Fracktal care for troubleshooting.

      Analysing the Gcode is one among the primary steps done while troubleshooting issues. The gcode which may be fine in your system may get corrupted while uploading to your printer. To make sure this corruption has not happened we recommend analysing ...
    • Material (filament) storage SOP

      3D printing filaments are hygroscopic in nature. PLA Nylon and PVA are extremly hygroscopic and storing them in air tight containers with dessicants is a must. Other filaments also need to be stored in air tight container but can be exposed to ...
    • SMPS not turning ON

      SMPS may not turn because of these reasons. 1. SMPS is not getting power supply. 2. SMPS is spoilt 3. SMPS is detecting a short in machine circuit and is auto Shutting. Troubleshooting: Note: Checking SMPS input when machine is on is risky task. You ...
    • Changing SMPS- Extended.

      Fractal Printers are designed with serviceability in mind. Changing SMPS in Julia Extended can be done with the help of a + Screw driver and 2.5mm Allen key (Allen Key is provided with the Accessory box).  Steps to replace SMPS: 1. Switch off the ...